TestPro CV100 LAN
LAN Validation
TestPro CV100 Smart
Smart Building Testing
TestPro CV100 Op
Fibre Optic Certification
Niva
GPON Analyser
eOLT
OLT Emulator
USB-Testbook
SIP/VoIP Trunk Tester
CCTS-03
Copper Talk Sets
ProfiShark 1G
Network Taps / Network Monitoring
TestPro CV100 Cu
LAN Cable Qualification
inSSIDer Office
WiFI Analysis
Spectrum Analysis
KE3700 xDSL Multitester
xDSL Broadband Testers
Net.Time
Synchronization Clocks
AT.2048
E1/G.703 Testers
Datacom Testers
Ether.Genius
Ethernet Testers
E1/G.703 Testers
Datacom Testers
Chanalyzer
Spectrum Analysis
xGenius
Ethernet Testers
E1/G.703 Testers
Datacom Testers
Wi-Spy-Air
Spectrum Analysis
WiFI Analysis
WiFi Packet Capture
Zeus
Ethernet Testers
E1/G.703 Testers
Datacom Testers
Eye P.A
WiFi Packet Capture
MGA2510
Ethernet Network Emulators
Ethernet Packet Capture
Ethernet Testers
Tamograph Pro
Site Survey
Ethernet Testers
E1/G.703 Testers
Datacom Testers
Network Taps / Network Monitoring
Copper Talk Sets
Zeus
Ethernet Testers
E1/G.703 Testers
Datacom Testers
LAN Validation
Ethernet Network Emulators
Ethernet Packet Capture
Ethernet Testers
SIP/VoIP Trunk Tester
eOLT
OLT Emulator
Niva
GPON Analyser
E1/G.703 Testers
Datacom Testers
Synchronization Clocks
xDSL Broadband Testers
Ethernet Testers
E1/G.703 Testers
Datacom Testers
Fibre Optic Certification
Smart Building Testing
LAN Validation
WiFI Analysis
Spectrum Analysis
LAN Cable Qualification
Site Survey
Spectrum Analysis
WiFI Analysis
WiFi Packet Capture
WiFi Packet Capture
Spectrum Analysis
L2 Button
Button Text

CCTS-03 Talk & Test Set

CCTS-03
CCTS-03
CCTS-03

Technicians Copper Talk Set

  • Lightweight and solid test set for testing telephone lines.
  • Allows for communication over dead telephone lines.
  • Test for: Reversals, Split Pairs, Shorts, Open, Ground Fault
  • Can be used on powered lines.
  • Microprocessor for tuning on live lines.

Kurth CCTS-03 Cable Conductor Talk & Test Set

The CCTS-03 cable conductor talk and test set can be used by two or more technicians to setup and communicate over dead telephone lines of up to 3000 Ohms or more, as well as test and tap-out telephone pairs. Housed in a rugged and solid ABS housing the CCTS-03 is designed to be used in the harshest environments, the unit also comes with a strong  Cordura pouch for added protection. Powered by a standard 9 Volt alkaline battery, the CCTS-03 can be used for extended periods with no requirement for an external power source.

Talk Set for Copper Pairs

To establish voice communication over a dead pair, users simply connect a CCTS-03 at each end of the cable. As long as both units are connected to the same pair, voice communication is established and users can talk using the supplied headsets.

Test Copper Pairs

After a new cable installation or after repair of an in-service cable, the cable needs to be tested for common faults like pair reversals, opens, shorts or ground faults. The CCTS-03 can test and tap-out pairs, with one unit in the RX-Mode and the other in the TX-Mode a test tone is heard when the test lead of each CCTS-03 is connected to the same conductor.

FAQS

Q:
Do you need power on the Pair that you wish to communicate on with the CCTS-03
A:

No, the CCTS03 is designed to be used on lines with no power, the CCTS-03 contains batteries and provides the power required in order to be able to communicate over a dry/dead line.

Q:
Can a single CCTS-03 be used to test pairs.
A:

No , you need a pair of CCTS03 units, one at each end of the copper pair you wish to test.

Q:
Does the CCTS-03 have a built in microphone and speaker
A:

No, the CCTS-03 uses an external headset which is supplied with the unit.

Q:
A: